What are some important cleaning locations for CNC plasma cutting machines?

According to the questions raised by the readers, Xiao Bian, after consulting the relevant technical personnel of Suzhou Jiaoyuehao Numerical Control Technology Co., Ltd., concluded that: CNC plasma cutting machines are affected by the environment in daily production and life, if the cleanliness of certain key parts is not High is very likely to cause these problems. Therefore, the cleaning of the CNC plasma cutting machine is indispensable. The four major parts that must be cleaned are: nozzle, protective cover, separatist, and wearing parts.

1. Nozzles When air or oxygen is used as the plasma gas, oxides will be deposited in the nozzles. This oxide will affect the cutting airflow and reduce the life of wearing parts. Wipe the inside of the nozzle with a clean fleece to eliminate oxides.

2. The protective cover should always remove the slag on the torch protection cover, otherwise this slag will cause a destructive "heavy plasma arc." In addition, it is best to apply splash-proof chemical paint on the protective cover. It will help to reduce slag accumulation on the protective cover. However, be sure to remove the protective cover from the torch before applying paint.

3, double-axis guide rails on the double-axis guide rail above the dust will affect the lateral movement, resulting in cutting machine accuracy is not high. It's okay to clean it with a brush or rag directly when cleaning. It's simple but it must be cleaned.

4. Any artifacts on the torch and consumables of the torch and consumables will seriously affect the function of the plasma system. When replacing consumables, place them on a clean flannel and always check the connection thread of the torch and clean the electrode contact surfaces and nozzles with hydrogen peroxide.

Rod Mill Machine

The ball mills are used to grind materials into extremely fine powder for use in mineral dressing processes, paints, pyrotechnics, ceramics and selective laser sintering. The materials are ground by Coriolis forces, an interaction between frictional and impact forces, as a result of difference in speeds between the balls and grinding jars.
The rolls rotate on precision bronze bearings and are simultaneously driven by a pinion stand. The roll height is adjustable independently or simultaneously through a side-wheel screw down assembly. There are entry and exit tables with adjustable guides installed on the entry table. Emergency stop bars will be installed on entry and exit of mill. In addition, all controls are in a centrally located operating station.

Rod Mill,Rod Mill For Grinding,Rod Mill Equipment,Rod Mill Machine

Shenyang Sanland Mining Equipment Manufacture Co., Ltd. , https://www.sanlandcrushers.com